You’re not looking for the cheapest drywall installer in Kensington South. You’re looking for someone who won’t leave gaps in the seams, won’t ghost you halfway through, and won’t turn your living room into a dust-covered disaster zone for three weeks.
Here’s what actually matters when you’re installing drywall. The seams disappear completely under paint. The texture matches your existing walls so well you forget where the new work starts. Your furniture stays covered, your floors stay protected, and when we leave, the only evidence we were there is how good your walls look.
Most drywall installation projects in Kensington South get finished in a single day. That’s measuring, cutting, hanging, taping, mudding, sanding, and cleanup. You don’t need to take a week off work or move out while we’re working. We show up when we say we will, we do what we said we’d do, and we’re gone before it disrupts your whole life.
The cost to install drywall depends on square footage and whether you’re dealing with ceilings, water damage, or just standard walls. We’ll tell you the exact price upfront, and that number doesn’t change unless you change the scope.
Sharpe Drywall started because too many homeowners in Montgomery and Bucks County were getting burned by contractors who didn’t finish jobs, left messes, or delivered work that looked worse than the original problem. We’re fully licensed and insured, and we’ve spent over a decade working in older Philadelphia-area homes where nothing is square, plumb, or simple.
Kensington South has its share of century-old rowhomes with plaster walls, settling foundations, and quirky layouts. We know how to tie new drywall into old plaster without cracking or buckling. We know which materials hold up in homes with humidity issues or seasonal movement.
You’re hiring local contractors who live in the area and plan to keep working here. That means we care about the quality of every install, because our reputation depends on it.
First, we measure everything and assess what you’re working with. If you’ve got water damage, we find the source and make sure it’s fixed before we hang new drywall. If you’re adding walls or finishing a space, we confirm the framing is solid and ready.
Then we cut and hang the drywall sheets. This is where precision matters—every edge needs to land on a stud, every corner needs to be tight, and every screw needs to sit just below the surface without tearing the paper. We’re not rushing through this part to get to the next job.
After the sheets are up, we tape and mud the seams. This takes multiple coats with sanding in between, and it’s the difference between seams that show through paint and seams that disappear completely. We match your existing texture if you’ve got it, or we apply a new finish that’s consistent across the whole surface.
Finally, we sand everything smooth, vacuum up the dust, wipe down surfaces, and haul away the scraps. You’re left with walls that are ready for primer and paint. Most residential drywall installation projects in Kensington South wrap up in one day unless you’re doing a whole house or dealing with major repairs.
Ready to get started?
The average cost to install drywall in Kensington South runs between $1.50 and $3.50 per square foot depending on the complexity. A standard 12×12 room with 8-foot ceilings usually falls between $800 and $1,500 for materials, labor, taping, mudding, and finishing. Ceilings cost more because they’re harder to work on. Repairs cost less if we’re patching small sections instead of hanging full sheets.
We use premium mold-resistant drywall in areas prone to moisture—bathrooms, basements, kitchens. It costs a bit more upfront, but it lasts years longer and prevents the kind of damage that leads to expensive repairs down the road. All our compounds are professional-grade, not the pre-mixed stuff from big box stores that shrinks and cracks after a few months.
You’ll get a detailed quote before we start. That quote includes materials, labor, cleanup, and haul-away. If we find something unexpected once we open up a wall—like old wiring that needs attention or hidden water damage—we’ll walk you through it and adjust the scope. But the price we quote is the price you pay unless you ask us to do something different.
Kensington South homeowners deal with a lot of foundation settling and old plumbing that leaks. If your walls have cracks that keep coming back or sections that feel soft to the touch, that’s a sign of a bigger issue. We’ll tell you what’s causing it so you can fix the root problem, not just cover it up with new drywall that’ll fail in six months.
Most single-room drywall installation projects in Kensington South get finished in one day. That includes hanging the sheets, taping and mudding the seams, sanding, and cleanup. If you’re doing a larger space—like finishing a basement or renovating multiple rooms—it might take two or three days depending on square footage and how many coats of mud the seams need.
The timeline also depends on what we’re working with. If your studs are already in place and there’s no demo work, we move faster. If we need to remove old damaged drywall first or address moisture issues before we hang new sheets, that adds time.
We don’t leave projects half-finished. Once we start, we stay until it’s done. You won’t be staring at exposed studs for a week waiting for us to come back.
Drywall repair means we’re patching holes, fixing cracks, or replacing small damaged sections—usually anything under a few square feet. We cut out the bad area, fit in a new piece, tape and mud the seams, and blend it into your existing wall. Repair work is faster and cheaper because we’re not touching the whole surface.
Full drywall installation means we’re hanging new sheets across entire walls or ceilings. This happens during renovations, additions, or when the existing drywall is too damaged to salvage. Installing drywall involves more labor, more material, and more finishing work because we’re covering larger areas and creating seams across the whole room.
If you’ve got a few nail pops or a small crack, that’s a repair. If half your ceiling is sagging from a roof leak or you’re gutting a room down to the studs, that’s a full install. We handle both, and we’ll tell you honestly which one makes sense for your situation.
Yes, and we see it constantly in this area. Most of the homes in Kensington South were built decades ago with old plumbing, outdated insulation, and roofs that have seen better days. Water finds its way in through leaks, condensation, or foundation cracks, and drywall doesn’t hold up well once it gets wet.
Before we replace water-damaged drywall, we find the source of the moisture and make sure it’s fixed. There’s no point installing new sheets if the same leak is going to ruin them in six months. Once the source is handled, we remove the damaged sections, check the framing and insulation behind it, and install mold-resistant drywall that’s designed to handle humidity better than standard sheets.
If you’ve got stains, soft spots, or sections that smell musty, don’t wait. Water damage spreads, and the longer it sits, the more expensive the fix becomes. We’ll assess it, give you a straight answer about what needs to be done, and get it handled before it turns into a bigger problem.
Basement drywall installation in Kensington South typically runs between $2,000 and $5,000 depending on the size and whether you’re finishing the ceiling too. Basements are tricky because they’re prone to moisture, the ceilings are often lower, and you’re usually working around mechanicals like ducts, pipes, and electrical.
We use moisture-resistant drywall in basements as a standard. It costs a bit more than regular drywall, but it’s worth it in below-grade spaces where humidity is higher. If your basement has had water issues in the past, we’ll recommend a vapor barrier or additional waterproofing before we hang anything.
The cost to install drywall also depends on how much prep work is involved. If your studs are already framed and your basement is dry, we move faster. If we need to furr out foundation walls or work around a maze of old plumbing, that adds labor. We’ll walk the space with you and give you an exact number based on what we’re looking at.
Yes. Texture matching is one of those things that separates decent drywall installers from good ones, and it’s something we’ve been doing for years in older Philadelphia homes where every room has a different finish.
If you’ve got knockdown, orange peel, skip trowel, or any other texture, we’ll replicate it so the repair blends in completely. This involves using the right tools, the right mud consistency, and the right technique. It’s not something you can fake—it either matches or it doesn’t, and bad texture work sticks out like a sore thumb once you paint over it.
Sometimes the existing texture is so old or unique that we need to do a test patch first to get it right. We’d rather take the extra time upfront than leave you with a repair that’s obvious every time you walk past it. If your whole wall needs to be redone and the texture is outdated, we can also apply a fresh modern finish across the entire surface so everything looks consistent.
Yes. We’re fully licensed and insured to work in Kensington South, Montgomery County, Bucks County, and throughout the Philadelphia area. That means if something goes wrong—which it won’t, but if it did—you’re protected. Your property is covered, our crew is covered, and you’re not stuck holding the bill for an accident.
A lot of drywall installers skip licensing and insurance because it costs money and requires accountability. That’s a red flag. If someone’s willing to cut corners on the legal side, they’re probably cutting corners on the work too.
We carry general liability insurance and workers’ comp. You can ask to see proof of both before we start, and we’ll send it over without hesitation. Hiring a licensed contractor isn’t just about following the rules—it’s about working with someone who’s serious about doing the job right and standing behind their work.
Local Resources
Useful Links
Other Services we provide in Kensington South
